 |
 |
 |
|
Maxim >
设计支持
> 应用笔记
>
[实时时钟]
[时间和温度记录器]
| |
关键词: DS32kHz, oscillator, timekeeping accuracy, temperature compensation, TCXO, 32768Hz, 32.768kHz, 32768 Hz, 32.768 kHz, crystal, real-time clock, WWV
|
|
相关型号
|
|
APP 701: Feb 15, 2002
|
下载,PDF格式 (70kB)
|
|
 |

| 应用笔记701
|
Using the DS32kHz with Dallas Real-Time Clocks |
Abstract: This application note describes how to reduce current consumption when using the DS32kHz with Dallas Real-Time Clocks (RTCs).
Overview
This application note is intended to answer some frequently asked questions about using the DS32kHz TCXO (temperature-compensated crystal oscillator) and Dallas Semiconductor real-time clocks (RTCs).
Using the DS32kHz
The DS32kHz has four pins that are required for operation: VCC, VBAT, GND, and 32kHz_OUT. The VCC, VBAT, and GND are power supply connections and must either be connected to a positive supply or grounded. The 32kHz_OUT signal is intended to drive the X1 input of the RTC. The X2 pin of the RTC should be allowed to float when driving the X1 input with an oscillator.
The DS32kHz ICC and IBAT specifications are measured with no output load. The input characteristics of the oscillator on a RTC will determine how much additional current the DS32kHz will consume. The additional current can significantly increase the size of the battery needed for operation.
Choosing an RTC
Dallas Semiconductor has a wide selection of RTCs from which to choose. Some of these devices were designed using a P-WELL process while the more recent devices have been designed using the first-generation N-WELL process. The second-generation N-WELL RTCs incorporate improvements that reduce the current consumption of the TCXO/RTC combination. The following data shows the current consumed by typical devices from each process. The data were taken at a battery voltage of 3.5V at +25°C.
KEY:
Ind = Individual Currents; DS32kHz with output open, RTC with crystal attached and running.
Direct = DS32kHz driving the RTC X1 input directly.
RC = DS32kHz driving the RTC with a 1MΩ resistor in series with a 100pF capacitor to the X1 input.
Table 1. N-WELL (First Generation)
| Mode |
DS32kHz IBAT (µA) |
DS1306 IBAT (nA) |
| Ind |
1.60 |
518 |
| Direct |
11.9 |
386 |
| RC |
2.14 |
584 |
Table 2. N-WELL (Second Generation)
| Mode |
DS32kHz IBAT (µA) |
DS1337 ICC (nA) |
| Ind |
1.59 |
612 |
| Direct |
3.73 |
626 |
| RC |
2.11 |
622 |
Table 3. P-WELL
| Mode |
DS32kHz IBAT (µA) |
DS1202 IBAT (nA) |
| Ind |
1.63 |
625 |
| Direct |
87.1 |
3,410 |
| RC |
2.17 |
685 |
Note the RTC in each of the aforementioned tables are different RTCs. This accounts for the difference in the clock currents when comparing the tables.
If the RTC has an oscillator-enable bit, the oscillator must be enabled. If the bit is not enabled, additional current will be drawn and the clock might not operate.
Table 4. RTC LIST
| P-WELL Devices |
First Generation N-WELL Devices |
Second Generation N-WELL Devices |
| DS1202 |
DS12885 |
DS1337 |
| DS12885 |
DS1302 |
DS1338 |
| DS1283 |
DS1305/DS1306 |
DS1339 |
| DS1284 |
DS1307 |
DS1672 |
| DS1384 |
DS1315 |
|
| DS14285 |
DS1500/DS1501 |
|
| DS1384 |
DS1315 |
|
| |
DS1602 |
|
| |
DS1670/DS1673/DS1677 |
|
| |
DS1685 |
|
| |
DS1688/DS1689 |
|
| |
DS17285/DS17485/DS17885 |
|
Summary
When using P-WELL and first-generation N-WELL RTC devices, use an RC circuit to achieve the minimum
possible timekeeping current.
The second-generation N-WELL devices use only slightly more current with an RC circuit.
| 相关型号 | |
APP 701: Feb 15, 2002
|
| DS1284 |
看门狗计时器 |
完整的数据资料 (PDF, 304kB)
|
|
| DS12885 |
实时时钟 |
完整的数据资料 (PDF, 240kB)
|
免费样品
|
| DS12R885 |
带有恒压涓流充电器的RTC |
完整的数据资料 (PDF, 856kB)
|
免费样品
|
| DS1302 |
带涓流充电的时钟芯片 |
完整的数据资料 (PDF, 348kB)
|
免费样品
|
| DS1305 |
带有闹钟的串行实时时钟 |
完整的数据资料 (PDF, 496kB)
|
免费样品
|
| DS1306 |
带有闹钟的串行实时时钟 |
完整的数据资料 (PDF, 388kB)
|
免费样品
|
| DS1307 |
64 x 8、串行、I²C实时时钟 |
完整的数据资料 (PDF, 304kB)
|
免费样品
|
| DS1315 |
隐含时钟芯片 |
完整的数据资料 (PDF, 324kB)
|
免费样品
|
| DS1337 |
I²C串行实时时钟 |
完整的数据资料 (PDF, 240kB)
|
免费样品
|
| DS1338 |
I²C RTC,带有56字节NV RAM |
完整的数据资料 (PDF, 268kB)
|
免费样品
|
| DS1339 |
I²C串行实时时钟 |
完整的数据资料 (PDF, 208kB)
|
免费样品
|
| DS1340 |
I²C RTC,带有涓流充电器 |
完整的数据资料 (PDF, 240kB)
|
免费样品
|
| DS1371 |
I²C、32位二进制计数器看门狗时钟 |
完整的数据资料 (PDF, 1.2MB)
|
免费样品
|
| DS1374 |
I²C、32位二进制计数器看门狗RTC,带有涓流充电器和复位输入/输出 |
完整的数据资料 (PDF, 200kB)
|
免费样品
|
| DS1384 |
看门狗实时时钟控制器 |
完整的数据资料 (PDF, 492kB)
|
|
| DS1390 |
低电压SPI/3线接口RTC,带有涓流充电器 |
完整的数据资料 (PDF, 388kB)
|
免费样品
|
| DS1391 |
低电压SPI/3线接口RTC,带有涓流充电器 |
完整的数据资料 (PDF, 388kB)
|
免费样品
|
| DS1392 |
低电压SPI/3线接口RTC,带有涓流充电器 |
完整的数据资料 (PDF, 388kB)
|
免费样品
|
| DS1393 |
低电压SPI/3线接口RTC,带有涓流充电器 |
完整的数据资料 (PDF, 388kB)
|
免费样品
|
| DS14285 |
实时时钟,带有非易失RAM控制器 |
完整的数据资料 (PDF, 520kB)
|
|
| DS1500 |
Y2K兼容、看门狗RTC,带有非易失控制 |
完整的数据资料 (PDF, 268kB)
|
免费样品
|
| DS1501 |
Y2K兼容、看门狗实时时钟 |
完整的数据资料 (PDF, 448kB)
|
免费样品
|
| DS1558 |
看门狗时钟,带有NV RAM控制器 |
完整的数据资料 (PDF, 304kB)
|
免费样品
|
| DS1602 |
历时计数器 |
完整的数据资料 (PDF, 224kB)
|
|
| DS1670 |
便携系统控制器 |
完整的数据资料 (PDF, 164kB)
|
免费样品
|
| DS1672 |
I²C、32位二进制计数器RTC |
完整的数据资料 (PDF, 200kB)
|
免费样品
|
| DS1673 |
便携系统控制器 |
完整的数据资料 (PDF, 224kB)
|
免费样品
|
| DS1677 |
便携系统控制器 |
完整的数据资料 (PDF, 232kB)
|
免费样品
|
| DS1678 |
实时事件记录器 |
完整的数据资料 (PDF, 196kB)
|
免费样品
|
| DS1685 |
3V/5V实时时钟 |
完整的数据资料 (PDF, 460kB)
|
免费样品
|
| DS1688 |
3V/5V、串行实时时钟,带有NV RAM控制器 |
完整的数据资料 (PDF, 100kB)
|
|
| DS1689 |
3V/5V、串行实时时钟,带有非易失RAM控制器 |
完整的数据资料 (PDF, 600kB)
|
|
| DS17285 |
3V/5V实时时钟 |
完整的数据资料 (PDF, 328kB)
|
免费样品
|
| DS17485 |
3V/5V实时时钟 |
完整的数据资料 (PDF, 328kB)
|
免费样品
|
| DS17885 |
3V/5V实时时钟 |
完整的数据资料 (PDF, 328kB)
|
免费样品
|
| DS32KHZ |
32.768kHz温补晶振 |
完整的数据资料 (PDF, 404kB)
|
免费样品
|
|
自动更新
需要自动接收最新发布的应用笔记吗?请订阅EE-Mail™ (English only)。
我们期待您的反馈! 喜欢?不喜欢?有待改善?或为我们提供建议?请与我们联系 — 我们将根据您的意见或建议改善我们的工作。
网页评价或提供建议
|
下载,PDF格式 (70kB)
AN701,
AN 701,
APP701,
Appnote701,
Appnote 701
|
|
|
 |
|
 |
|
|