 |
|
|
|
|
|
| 应用笔记3499
|
Compact-Footprint, 60A, Two-Phase Power Supply for AMD K8 Motherboards |
Abstract: This application note describes a compact-footprint, low-cost, 60A, two-phase solution for desktop motherboard applications using AMD K8 CPUs. Test data, schematics, and bill of materials are included. The regulator operates from a 12V input and delivers a peak efficiency of 90% with a four-layer, 1oz. copper PC board typically employed in desktop designs. It features a 5in x 1.3in regulator area footprint, and uses low-cost components. Adequate airflow is necessary to ensure that the board/component temperature rise is within acceptable limits for the required operating ambient-temperature range.
The power supply is implemented using the MAX1937 Quick-PWM™ controller. The Quick-PWM architecture regulates the output voltage by driving the output inductor with a constant on-time pulse whenever the output-voltage ripple waveform falls below a reference voltage (Figure 1). The next pulse is applied to the inductor after a fixed minimum off-time, if the output voltage has fallen below the reference. Unlike fixed-frequency controllers that have to wait for the next clock pulse to service load transients, the Quick-PWM control architecture responds after the minimum off-time (350ns for the MAX1937) has elapsed. This ensures fast response under load-transient conditions. The steady-state switching frequency can still be low (180kHz in this design) to maximize efficiency.
Load-transient response (Figure 2) and efficiency data (Figure 3) are shown, along with a bill of materials (Table 1) and schematics of a two-phase power supply for AMD K8 motherboards (Figures 4a and 4b).
Figure 1. Quick-PWM operation.
Figure 2. Load-transient response.
Figure 3. Efficiency (VIN = 12V, VOUT = 1.5V).
Table 1. Bill of Materials
| DESIGNATION |
QTY |
DESCRIPTION |
| C1, C2, C20, C64 |
4 |
1500µF, 16V capacitors
Rubycon 16VMBZ1500 |
| C3, C9 |
2 |
10µF, 16V capacitors (1210)
Taiyo Yuden CE EMK325 BJ106MN-T |
| C4, C6 |
2 |
0.22µF, 10V X7R capacitors (0603)
Taiyo Yuden CE LMK107 BJ334KA-T |
| C5, C7 |
2 |
1000pF, 6.3V X7R capacitors (0603)
Murata GRM39X7R102K |
| C8 |
1 |
2.2µF, 6.3V capacitor (0603)
Taiyo Yuden CE JMK107 BJ105MA-T |
| C10 |
1 |
820pF, C0G capacitor (0603)
Murata GRM39C0G821J050 |
| C11, C14 |
1 |
0.22µF, 10V X7R capacitors (0603)
Taiyo Yuden CE LMK107 BJ224KA-T |
| C12, C13 |
2 |
2200pF, 6.3V X7R capacitors (0603)
Murata GRM39X7R222K |
| C15 |
1 |
47pF, 50V C0G capacitors (0603)
Murata GRM39C0G470J050AD |
| C16 |
1 |
Not used |
| C17 |
1 |
0.47µF, 10V X5R capacitor (0603)
Taiyo Yuden CE LMK107 BJ474KA-T |
| C18, C19 |
2 |
0.0022µF, 50V capacitors (0805)
Murata GRM39X7R222K50 |
| C21 |
1 |
0.1µF, 25V X7R capacitor (0603)
Murata GRM188R71E104KA01B |
| C22-C27 |
6 |
3300µF, 6.3V capacitors
Rubycon 6.3VMBZ3300,
12ΩWMAX ESR |
| C28-C33, C34-C39 |
12 |
10µF capacitors (1206)
Taiyo Yuden CE JMK316 BJ106ML-T |
| C40-C47, C48-C61 |
22 |
2.2µF capacitors (0603)
Taiyo Yuden JMK107BJ225MA |
| C62-C63, C67-C70 |
6 |
22µF X5R capacitors (1206)
Taiyo Yuden JMK316BJ226ML |
| R1 |
1 |
10Ω ±5% resistor (0603) |
| R2, R5 |
2 |
3.3Ω ±5% resistors (0603) |
| R3 |
1 |
10kΩ ±5% resistor (0603) |
| R4, R7, R8, R9 |
4 |
200Ω ±5% resistors (0603) |
| R6 |
2 |
20kΩ ±1% resistor (0603) |
| R16, R17 |
2 |
68.1kΩ ±5% resistors (0603) |
| R8, R9 |
2 |
200Ω ±5% resistors (0603) |
| R10 |
1 |
100kΩ ±1% resistor (0603) |
| R11 |
1 |
2kΩ ±5% resistor (0603) |
| R12 |
1 |
120kΩ ±1% resistor (0603) |
| R13 |
1 |
80.6kΩ ±1% resistor (0603) |
| R14, R15 |
2 |
200kΩ ±1% resistors (0603) |
| R18, R19 |
2 |
3.3Ω ±5% resistors (1206) |
| R20 |
1 |
Open (0603) |
| R21 |
1 |
390Ω ±1% resistor (0603) |
| R22 |
1 |
1.5kΩ ±1% resistor (0603) |
| R29 |
1 |
2.2Ω ±5% resistor (0603) |
| L1, L2 |
1 |
1.2µH, 30A toroidal inductors
BI Technologies HM00-3583 |
| L3 |
1 |
0.33µH, 10A toroidal inductor
BI Technologies HM00-3661 |
| D1 |
1 |
Dual Schottky diodes (SOT23)
Central CMSSH-3A |
| D2, D3 |
2 |
Diodes (SOT23)
Central Semiconductor CMPD2836 |
| J1-J6, J9 |
7 |
2-pin headers |
| Q3, Q4, Q7, Q8 |
4 |
N-channel MOSFETs (D2-Pak)
International Rectifier IRLR7833S |
| Q1, Q2, Q5, Q6 |
4 |
N-channel MOSFETs (D-Pak),
International Rectifier IRLR7821 |
| Q9, Q10 |
2 |
N-channel MOSFETs (SOT23)
Vishay 2N7002 |
| U1 |
1 |
Maxim MAX1937EEI controller (QSOP) |
| U2 |
1 |
National LM317 regulator (D-Pak) |
| J7 |
1 |
4-pin ATX Molex connector |
| J8 |
1 |
PGA socket 754
Foxconn PZ75403-2948-01 |
| PC board |
1 |
Maxim MAX1937 K8 evaluation kit,
8/03, compact footprint |
For Larger Image
Figure 4a. 60A, Two-Phase Power Supply for AMD K8 Motherboards (VIN = 12V, VOUT = 1.5V at 60A)
Figure 4b. 60A, Two-phase power supply for AMD K8 motherboards.
| 相关型号 | |
APP 3499: May 11, 2005
|
|
|
自动更新
需要自动接收最新发布的应用笔记吗？请订阅EE-Mail™ (English only)。
我们期待您的反馈！
喜欢？不喜欢？有待改善？或为我们提供建议？请与我们联系 — 我们将根据您的意见或建议改善我们的工作。
网页评价或提供建议
|
 下载，PDF格式 (103kB)
AN3499,
AN 3499,
APP3499,
Appnote3499,
Appnote 3499
|
|
|
|
|
|
|
|
